DIY Kit Extended

5 in stock

Complete kit with fader – The original Beatmaker’s sketchbook



5 in stock

5 in stock

Support the Open-Source firmware development! Get mentioned as a supporter in the firmware (min. 25€), visible on every device. Choose your support level..
Make your Beatmaker's sketchbook portable! With battery power and speakers. The Power Management Board from Adafruit charges the battery via the Teensy USB port. Batteries can only be shipped to locations in Germany.
Book a one hour support session for trouble shooting, help or just a chat with the maker.
Product total
Options total
Grand total

All prices include 19% VAT (Germany)

The original Beatmaker’s sketchbook DIY kit with a fader in the middle for fast sample cutting.

The kit comes without enclosure and caps.


  • Beatmaker’s sketchbook main PCB with fader option
  • Audio codec PCB (assembled)
  • Teensy 4.1
  • 2 PSRAM chips for 16MB sample memory on the Teensy
  • 32GB SD-Card
  • 2″ IPS Display
  • Resistors / Condensators / Diode
  • 33 LEDs (24 green, 9 red)
  • Volume potentiometer
  • Buttons (24 cherry mx low profile, 13 pushbuttons)
  • 4 Encoders
  • 10cm Fader (slide potentiometer)
  • Connector set (2x male, 2x female á 50 PINS)
  • ICs (5x MCP23017, 1x Optocoupler)
  • Jacks (2x Midi, 2x Line, 1x Headphone)
  • Microphone

You need the following:

  • Soldering equipment
  • A Computer with Windows, Mac OS or Linux to upload new firmware. See for details.
  • Standard USB Cable with 5 Pin Micro-B Connector

For needed tools, check the soldering guide.


Go to Top